Use the same procedure for RHD and LHD vehicles.
The procedure below is for LHD vehicles.
53301
1.INSPECT HOOD SUB-ASSEMBLY
Check that the clearance measurements of areas A to K are within the standard ranges.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 1.85 to 5.85 mm (0.0728 to 0.2303 in.) | B
(Reference) |
8.05 mm (0.317 in.) |
| C | 1.85 to 5.85 mm (0.0728 to 0.2303 in.) | D | -1.85 to 2.15 mm (-0.0728 to 0.0846 in.) |
| E
(Reference) |
7.95 mm (0.313 in.) | F | 3.5 to 6.5 mm (0.138 to 0.256 in.) |
| G | 1.7 to 4.7 mm (0.0669 to 0.1850 in.) | H | 3.5 to 6.5 mm (0.138 to 0.256 in.) |
| I | 0.4 to 3.4 mm (0.0157 to 0.1339 in.) | J | 2.8 to 5.8 mm (0.110 to 0.228 in.) |
| K | -1.8 to 1.2 mm (-0.0709 to 0.0472 in.) | - | - |
If the result is not as specified, adjust the hood sub-assembly.