Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › THROTTLE BODY
RM3620E _51 Engine / Hybrid System _076383 A25A-FXS ENGINE CONTROL _0372611 THROTTLE BODY A

A25A-FXS ENGINE CONTROL  THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


w/ Canister Pump Module:(Click here)
w/o Canister Pump Module:(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17750A 3.REMOVE INLET AIR CLEANER ASSEMBLY

a.
A424095

Remove the 2 bolts and inlet air cleaner assembly.


Hide 4.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

a.
A424096

Disconnect the mass air flow meter sub-assembly connector.


b.

Detach the wire harness clamp.


c.
A424097C01
2.271,4.323 1.24,4.323 1.24,4.323 2.75,4.01 true 2.542,4.281 2.771,4.438 2.771,4.438 2.927,4.438 true 1.063,4.229 1.281,4.469 0.219,0.24 10 false *a 2.969,4.333 3.188,4.552 0.219,0.219 10 false *b
*a Grommet
*b Pin


Slide the clip and disconnect the No. 2 PCV hose from the cylinder head cover sub-assembly.


d.

Loosen the hose clamp and disconnect the air cleaner hose from the throttle body with motor assembly.


e.

Detach the 2 grommets and pin to remove the air cleaner assembly with air cleaner hose.


Hide 22030 5.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A424098

Disconnect the throttle body with motor assembly connector.


b.

Slide the clip and disconnect the No. 5 water by-pass hose from the throttle body with motor assembly.


c.

Remove the 3 bolts and disconnect the throttle body with motor assembly from the intake manifold.


d.

Slide the clip and disconnect the No. 6 water by-pass hose to remove the throttle body with motor assembly.

NOTICE:

If the throttle body with motor assembly has been struck or dropped, replace it.



e.
A424099

Remove the throttle body gasket from the intake manifold.