Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › MASS AIR FLOW METER
RM3620E _51 Engine / Hybrid System _076383 A25A-FXS ENGINE CONTROL _0372613 MASS AIR FLOW METER G

A25A-FXS ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

HINT:

Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.



a.

Read the value of Data List item "Mass Air Flow Sensor" using the GTS.

NOTICE:

Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).


i.

Connect the GTS to the DLC3.


ii.

Turn the power switch on (IG).


iii.

Turn the GTS on.


iv.

Put the engine in Inspection Mode (Maintenance Mode).

Powertrain > Hybrid Control > Utility
Tester Display
Inspection Mode
50005 397 2103

v.

Start the engine.


vi.

Enter the following menus: Powertrain / Engine / Data List / Mass Air Flow Sensor.

Powertrain > Engine > Data List
Tester Display
Mass Air Flow Sensor
50003 372 215

vii.

According to the display on the GTS, read the Data List when the engine is running.

Standard Condition:
GTS Display Condition Specified Condition
Mass Air Flow Sensor Idling (shift lever in P, engine warmed up, inspection mode [maintenance mode] and not charge control) 2.6 to 8.6 gm/sec
2500 rpm (shift lever in P, engine warmed up and inspection mode [maintenance mode]) 6.2 to 18.6 gm/sec


If the result is not as specified, replace the mass air flow meter sub-assembly.

If the result is within the specified range, remove and inspect the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION