Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM3620E _51 Engine / Hybrid System _076383 A25A-FXS ENGINE CONTROL _0372615 CRANKSHAFT POSITION SENSOR A

A25A-FXS ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:

If reusing the crankshaft position sensor, be sure to inspect the O-ring.



b.

Install the crankshaft position sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.




c.

Connect the crankshaft position sensor connector.


Hide 17750A 2.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 3.INSPECT FOR ENGINE OIL LEAK