This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Perform "Inspection After Repair" after replacing an ignition coil assembly and spark plug.
w/ Canister Pump Module:
Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module:
19100P
1.INSTALL SPARK PLUG
19500
2.INSTALL IGNITION COIL ASSEMBLY
Perform "Inspection After Repair" after replacing an ignition coil assembly.
w/ Canister Pump Module:
Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module:
Install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.
If an ignition coil assembly has been struck or dropped, replace it.
Connect the 4 ignition coil assembly connectors.
12601B
3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY