The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below.
12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
89467B
2.REMOVE AIR FUEL RATIO SENSOR
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
for Sensor 1:
Detach the 3 wire harness clamps.
Disconnect the air fuel ratio sensor connector.
Using SST, remove the air fuel ratio sensor from the exhaust manifold.
If the air fuel ratio sensor has been struck or dropped, replace it.
for Sensor 2:
Detach the 2 wire harness clamps.
Disconnect the air fuel ratio sensor connector.
Using SST, remove the air fuel ratio sensor from the front exhaust pipe assembly.
If the air fuel ratio sensor has been struck or dropped, replace it.