This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Perform "Inspection After Repair" after replacing the knock control sensor.
Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
89615
1.INSTALL KNOCK CONTROL SENSOR
Perform "Inspection After Repair" after replacing the knock control sensor.
Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
| *a | Top |
| *b | Right of Vehicle |
| *c | 15° |
| *d | 5° |
Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
If the knock control sensor has been struck or dropped, replace it.
Make sure that the knock control sensor is in the correct position.
Connect the knock control sensor connector.
27020
2.INSTALL GENERATOR ASSEMBLY
for 100 A, 130 A Type:
Click herePower Source / Network>M20A-FKS (BATTERY / CHARGING)>GENERATOR(for 100 A, 130 A Type)>INSTALLATION
for 150 A Type:
Click herePower Source / Network>M20A-FKS (BATTERY / CHARGING)>GENERATOR(for 150 A Type)>INSTALLATION