The forward recognition camera stores a DTC when a malfunction is detected in the camera.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C10001C | Control Module Internal Temperature Sensor "A" Circuit Circuit Voltage Out of Range | An internal malfunction was detected in the forward recognition camera | Forward recognition camera |
| C10051C | Control Module Internal Temperature Sensor "B" Circuit Circuit Voltage Out of Range | An internal malfunction was detected in the forward recognition camera | Forward recognition camera |
| C100A62 | Control Module Internal Temperature Sensor A/B Correlation Signal Compare Failure | An internal malfunction was detected in the forward recognition camera | Forward recognition camera |
| C1A9346 | Main Microcomputer in Front Recognition Camera Calibration/Parameter Memory Failure | An internal malfunction was detected in the forward recognition camera | Forward recognition camera |
| C1A9445 | Image Processing Microcomputer in Front Recognition Camera Program Memory Failure | An internal malfunction was detected in the forward recognition camera | Forward recognition camera |
| C1A9447 | Image Processing Microcomputer in Front Recognition Camera Watchdog/Safety MCU Failure | An internal malfunction was detected in the forward recognition camera | Forward recognition camera |
| C1A9487 | Image Processing Microcomputer to Main Microcomputer in Front Recognition Camera Missing Message | An internal malfunction was detected in the forward recognition camera | Forward recognition camera |
| C1A9500 | Image Processing Module Malfunction in Front Recognition Camera | An internal malfunction was detected in the forward recognition camera | Forward recognition camera |
| C1A961C | Power Supply Circuit in Front Recognition Camera Circuit Voltage Out of Range | An internal malfunction was detected in the forward recognition camera | Forward recognition camera |
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.
Forward recognition camera adjustment can be performed by using either "One Time Recognition" or "Sequential Recognition".
One Time Recognition:
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)
Sequential Recognition:
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch off.
Turn the ignition switch to ON and wait for at least 80 seconds or more.
Recheck for DTCs and check that no DTCs are output.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA SYSTEM>DTC CHECK / CLEAR
DTCs C10001C, C10051C, C100A62, C1A9346, C1A9445, C1A9447, C1A9487, C1A9500 and C1A961C are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG