Home › Drivetrain › EG62F (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSAXLE SYSTEM
RM3620E _52 Drivetrain _076271 EG62F MANUAL TRANSMISSION / TRANSAXLE _0372179 MANUAL TRANSAXLE SYSTEM D

EG62F MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM  ROAD TEST  


CHECK FOR DTC


a.

Check for DTCs.

Powertrain > Engine > Trouble Codes
50001 372
HINT:

When DTCs are output, perform troubleshooting for each DTC.

Click hereDrivetrain>EG62F (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSAXLE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART




CHECK iMT INDICATOR LIGHT


a.

Operate the iMT switch and check that the iMT indicator light illuminates and turns off.

HINT:

If the iMT indicator light does not illuminate, refer to "iMT indicator light does not illuminate" in the problem symptoms table.

Click hereDrivetrain>EG62F (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSAXLE SYSTEM>PROBLEM SYMPTOMS TABLE




ROAD TEST


CAUTION:
·
A371909

Strictly observe posted speed, limits, traffic laws and road conditions.

·

Do not drive the vehicle with the cable of the GTS contacting the pedals, shift lever or steering wheel.

·

Driving the vehicle with the cable of the GTS contacting these areas could impede vehicle control, resulting in a serious accident.


·
A356953

Do not operate the GTS while driving the vehicle.

·

Operating the GTS while driving the vehicle will prevent you from paying sufficient attention to vehicle surroundings, and could result in a serious accident.



HINT:
·

Make sure to perform this procedure with the iMT indicator light illuminated.

·

Make sure to securely depress the clutch pedal.



a.

Connect the GTS to the DLC3.


b.

Start the engine.


c.

Turn the GTS on.


d.

Operate the iMT switch and check that the iMT indicator (green) turns on.


e.

Enter the following menus: Powertrain / Engine / Data List.


f.

According to the display on the GTS, read the Data List.

Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Engine Speed Engine speed Min.: 0 rpm
Max.: 16383 rpm
600 to 700 rpm: Engine idling (shift lever in neutral, engine warmed up and A/C off) When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.
Powertrain > Engine > Data List
Tester Display
Engine Speed
50003 372 211

g.

Drive the vehicle in 3rd gear with an engine speed of 2000 rpm.


h.

Fully depress the clutch pedal, immediately downshift to 2nd gear and keep the clutch pedal depressed.


i.

After 2 seconds have elapsed since the clutch pedal was depressed, check the engine speed.

OK:

The engine speed is more than 2500 rpm.