Home › Drivetrain › EG62F (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSAXLE SYSTEM
RM3620E _52 Drivetrain _076271 EG62F MANUAL TRANSMISSION / TRANSAXLE _0372179 MANUAL TRANSAXLE SYSTEM D

EG62F MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM  DTC CHECK / CLEAR  


CHECK DTC (Using GTS)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 372

e.

According to the display in the GTS, read the DTCs and freeze frame data and make a note of them.




CLEAR DTC (Using GTS)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.


e.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 372


CLEAR DTC (When Not Using GTS)


a.

Perform either of the following operations:

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


·

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.

·

Remove the EFI-MAIN NO. 4 fuse from the No. 1 engine room relay block and junction block assembly located inside the engine compartment for more than 1 minute.