CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
| *A | w/o HI/MID/LO Type Front Seat Heater | *B | w/ HI/MID/LO Type Front Seat Heater |
Disconnect the G46 air conditioning amplifier assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G46-5 (B) - Body ground | G - Body ground | Power source (+B) | Ignition switch off | 11 to 14 V |
| G46-6 (IG+) - Body ground | GR - Body ground | Power source (IG) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| G46-17 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the G46 air conditioning amplifier assembly connector.
Measure the voltage and check for pulses according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
|
*1: for HV Model *2: for Gasoline Model |
||||
| G47-18 (RDFG) - Body ground | L - Body ground*1
SB - Body ground*2 |
Rear window defogger signal | Ignition switch ON, window defogger switch off | 11 to 14 V |
| Ignition switch ON, window defogger switch on | Below 1 V | |||
| G46-7 (LIN1) - Body ground | BE - Body ground | LIN communication line | Ignition switch ON | Pulse generation |