Home › Vehicle Interior › POWER OUTLETS (INT) › WIRELESS CHARGING SYSTEM
RM3620E _58 Vehicle Interior _076279 POWER OUTLETS (INT) _0371450 WIRELESS CHARGING SYSTEM J

POWER OUTLETS (INT)  WIRELESS CHARGING SYSTEM  Wireless Charger Illumination Circuit  


DESCRIPTION

When the taillight on, this circuit sends an illumination signal to the mobile wireless charger cradle assembly.

WIRING DIAGRAM

E414036E01
0.427,1.25 1.5,1.49 1.073,0.24 10 false from TAIL Relay 2.344,1.458 3.115,1.656 0.771,0.198 10 false PANEL 3.635,1.146 3.948,1.344 0.313,0.198 10 false 10 3.979,1.156 4.594,1.354 0.615,0.198 10 false TAIL 5.885,0.521 6.656,0.719 0.771,0.198 10 false 3.3 V 5.417,2.854 6.188,3.052 0.771,0.198 10 false 3.3 V 6.156,3.052 6.927,3.25 0.771,0.198 10 false 3.3 V 6.344,3.396 6.656,3.594 0.313,0.198 10 false IC 1.948,2.74 2.406,2.938 0.458,0.198 10 false I/F 3.729,3.25 3.885,3.448 0.156,0.198 10 false 9 3.979,3.26 4.49,3.458 0.51,0.198 10 false ILL- 2.385,3.26 2.896,3.458 0.51,0.198 10 false ILL- 2.76,3.25 3.073,3.448 0.313,0.198 10 false 35 1.094,3.688 1.552,3.885 0.458,0.198 10 false G18 1.094,3.854 2.979,4.104 1.885,0.25 10 false Combination Meter Assembly 4.146,4.802 4.604,5 0.458,0.198 10 false G13 4.135,4.99 6.823,5.24 2.688,0.25 10 false Mobile Wireless Charger Cradle Assembly 0.135,5.333 1.896,5.604 1.76,0.271 10 false *: w/ Light Control Rheostat 0.229,2.26 0.417,2.5 0.188,0.24 12 false *

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuse for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK VEHICLE TYPE
a.

Check vehicle type.


Result:
Result Proceed to
w/o Light Control Rheostat A
w/ Light Control Rheostat B



A

2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)

B

3.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
2.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
a.
E410400C02
1.5,0.156 1.906,0.417 0.406,0.26 2.333,1.99 2.125,1.99 2.125,1.99 1.813,1.542 true 0.063,0.063 0.375,0.219 0.313,0.156 10 false *a 1.573,0.198 2.031,0.396 0.458,0.198 10 false G13 2.417,1.885 2.813,2.073 0.396,0.188 10 false TAIL
*a Front view of wire harness connector
(to Mobile Wireless Charger Cradle Assembly)


Disconnect the mobile wireless charger cradle assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G13-10 (TAIL) - Body ground Light control switch in off position Below 1 V
Ignition switch off, light control switch in tail or head position 11 to 14 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
a.
E410400C02
1.5,0.156 1.906,0.417 0.406,0.26 2.333,1.99 2.125,1.99 2.125,1.99 1.813,1.542 true 0.063,0.063 0.375,0.219 0.313,0.156 10 false *a 1.573,0.198 2.031,0.396 0.458,0.198 10 false G13 2.417,1.885 2.813,2.073 0.396,0.188 10 false TAIL
*a Front view of wire harness connector
(to Mobile Wireless Charger Cradle Assembly)


Disconnect the mobile wireless charger cradle assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G13-10 (TAIL) - Body ground Light control switch in off position Below 1 V
Ignition switch off, light control switch in tail or head position 11 to 14 V



Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - MOBILE WIRELESS CHARGER CRADLE ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - MOBILE WIRELESS CHARGER CRADLE ASSEMBLY)
a.

Disconnect the G18 combination meter assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G18-35 (ILL-) - G13-9 (ILL-) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR