22204
1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY
Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.
w/ Canister Pump Module:
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module:
Read the value of Data List item "Mass Air Flow Sensor" using the GTS.
Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / Mass Air Flow Sensor.
| Tester Display |
|---|
| Mass Air Flow Sensor |
According to the display on the GTS, read the Data List when the engine is running.
| GTS Display | Condition | Specified Condition |
|---|---|---|
| Mass Air Flow Sensor | Idling (engine warmed up) | 1.2 to 3.2 gm/sec |
| 2000 rpm (without load) | 4.5 to 8.5 gm/sec | |
| 3000 rpm (without load) | 7.5 to 12.5 gm/sec |
If the result is not as specified, replace the mass air flow meter sub-assembly.
If the result is within the specified range, remove and inspect the mass air flow meter sub-assembly.
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION