Home › Engine / Hybrid System › A25A-FKS (ENGINE CONTROL) › KNOCK SENSOR
RM3620E _51 Engine / Hybrid System _076382 A25A-FKS ENGINE CONTROL _0373081 KNOCK SENSOR A

A25A-FKS ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.



PROCEDURE

Hide 89615 1.INSTALL KNOCK CONTROL SENSOR

HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.



a.
A432684C01
1.625,2.083 1.865,2.281 0.24,0.198 10 false *a 0.646,3.958 0.896,4.188 0.25,0.229 10 false *b 1.24,2.5 1.438,2.688 0.198,0.188 10 false *c 1.781,2.479 1.969,2.667 0.188,0.188 10 false *d
*a Top
*b Right of Vehicle
*c 15°
*d 5°


Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If the knock control sensor has been struck or dropped, replace it.

·

Make sure that the knock control sensor is in the correct position.




b.

Connect the knock control sensor connector.