16261G
1.INSTALL FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE)
Install the flow shutting valve (No. 1 water by-pass hose) with the bolt.
Connect the flow shutting valve connector.
Connect the flow shutting valve (No. 1 water by-pass hose) to the transmission oil cooler and slide the clip to secure it.
| *a | View A | *b | 90° |
| *c | Upper Side | *d | RH Side |
| *e | 2 to 7 mm (0.0787 to 0.276 in.) | - | - |
Make sure to slide the flow shutting valve (No. 1 water by-pass hose) until it contacts the hose stopper of the transmission oil cooler.
Make sure that the tabs of the clip are within the area shown in the illustration.
| *a | View A |
| *b | 90° |
| *c | Upper Side |
| *d | RH Side |
| *e | 2 to 7 mm (0.0787 to 0.276 in.) |
Connect the flow shutting valve (No. 1 water by-pass hose) to the water outlet and slide the clip to secure it.
Make sure to slide the flow shutting valve (No. 1 water by-pass hose until it contacts the hose) stopper of the water outlet.
Make sure that the tabs of the clip are within the area shown in the illustration.
Attach the 2 clamps to connect the flow shutting valve (No. 1 water by-pass hose) and transmission breather hose to the hose clamp.
Attach the 3 clamps to install the hose clamp.
Attach the 3 clamps to install the transmission breather clamp.
74404B
2.INSTALL BATTERY CLAMP SUB-ASSEMBLY
28800
3.INSTALL BATTERY
89661
4.INSTALL ECM
5.ADD ENGINE COOLANT
6.INSPECT FOR COOLANT LEAK
53737D
7.INSTALL FRONT FENDER APRON SEAL LH
51420
8.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
51441
9.INSTALL NO. 1 ENGINE UNDER COVER
53896B
10.INSTALL FRONT FENDER FRONT SPLASH SHIELD LH
53895B
11.INSTALL FRONT FENDER FRONT SPLASH SHIELD RH
12.INSTALL FRONT WHEEL LH