Home › Engine / Hybrid System › A25A-FXS (COOLING) › COOLING SYSTEM
RM3620E _51 Engine / Hybrid System _076660 A25A-FXS COOLING _0373134 COOLING SYSTEM G

A25A-FXS COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A434795

Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK (for Engine)

CAUTION:

Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.

Remove the radiator cap sub-assembly.


b.
A434796C01
0.5,0.688 0.656,0.688 0.656,0.688 0.865,1.063 true 0.25,0.594 0.479,0.802 0.229,0.208 10 true *a
*a Radiator Cap Tester


Fill the radiator assembly with engine coolant, and then install a radiator cap tester.


c.

Put the engine in Inspection Mode (Maintenance Mode).

i.

Connect the GTS to the DLC3.


ii.

Turn the power switch on (IG).


iii.

Turn the GTS on.


iv.

Enter following menus: Powertrain / Hybrid Control / Utility / Inspection Mode.

Powertrain > Hybrid Control > Utility
Tester Display
Inspection Mode
50005 397 3103


d.

Warm up the engine.


e.

Pump the radiator cap tester to 103 kPa (1.1 kgf/cm2, 15 psi), and then check that the pressure does not drop.

·

If the pressure drops, check the hoses, radiator assembly and engine water pump assembly (water inlet housing) for leaks.

·

If there are no signs of external engine coolant leaks, check the heater core, cylinder block sub-assembly and cylinder head sub-assembly.



f.

Remove the radiator cap tester.


g.

Install the radiator cap sub-assembly.


Hide 2.INSPECT ENGINE COOLANT LEVEL IN RESERVOIR (for Engine)

a.
A435753C01
2.146,1.729 2.469,1.5 2.469,1.5 2.604,1.5 true 2.156,1.188 2.479,0.958 2.479,0.958 2.615,0.958 true 2.677,0.885 2.99,1.042 0.313,0.156 10 false *a 2.677,1.427 2.99,1.583 0.313,0.156 10 false *b
*a Full Line
*b Low Line


Check that the engine coolant level is between the low line and full line when the engine is cold.

If the engine coolant level is low, check for leaks and add engine coolant to the full line.

NOTICE:

Do not substitute plain water for engine coolant.



Hide 3.INSPECT ENGINE COOLANT QUALITY (for Engine)

CAUTION:

Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.

Remove the radiator cap sub-assembly.


b.

Check if there are any excessive deposits of rust or scale around the radiator cap sub-assembly and water filler hole. Also, the engine coolant should be free of oil.

If excessively dirty, replace the engine coolant.


c.

Install the radiator cap sub-assembly.