The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly (water inlet housing) removal/installation are shown below.
After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
16031
1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
16032
2.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)
Disconnect the sensor wire connector.
Using an 8 mm socket wrench, remove the bolt and disconnect the sensor wire from the engine water pump assembly (water inlet housing).
Disconnect the engine water pump assembly (water inlet housing) connector.
Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block assembly.
Remove the gasket from the engine water pump assembly (water inlet housing).