Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
85035
1.INSPECT WASHER NOZZLE SUB-ASSEMBLY
With the ignition switch to ON, check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.
Washer fluid hits the windshield in the area shown in the illustration.
| *a | Ceramic Edge | *b | Upper Limit |
| *c | Standard | *d | Lower Limit |
| *e | Tolerance MAX | *f | Tolerance NOMINAL |
| *g | Tolerance MIN | - | - |
|
Landing Area | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 314.8 mm (1.03 ft.) | B | 184 mm (7.24 in.) |
| C | 125.1 mm (4.93 in.) | - | - |