Use the same procedure for the RH and LH sides.
The procedure below is for the LH side.
53341B
1.REMOVE HOOD INSULATOR
85035
2.REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)
|
Protective Tape |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Using a screwdriver with its tip wrapped with protective tape, detach the claw as indicated by the arrows, in the order shown in the illustration to separate the washer nozzle sub-assembly.
Be careful not to damage the windshield glass.
Disconnect the washer hose to remove the washer nozzle sub-assembly.
Washer nozzle sub-assemblies cannot be reused.
85035
3.REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/ Heater)
|
Washer Hose |
|
Connector |
Disconnect the connector and washer hose.
Detach the clamp.
|
Protective Tape |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Using a moulding remover D with its tip wrapped with protective tape, detach the claw as indicated by the arrows, in the order shown in the illustration to separate the washer nozzle sub-assembly.
Be careful not to damage the windshield glass.
Washer nozzle sub-assemblies cannot be reused.