This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
89458H
1.INSTALL NO. 2 FUEL PRESSURE SENSOR
Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.
Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
Install a new O-ring to the No. 2 fuel pressure sensor.
Install the No. 2 fuel pressure sensor to the fuel delivery pipe sub-assembly.
Do not allow dust or dirt to enter the No. 2 fuel pressure sensor.
If a No. 2 fuel pressure sensor is dropped or struck, replace it with a new one.
Install the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the bolt.
Connect the connector to the No. 2 fuel pressure sensor.
25620
2.INSTALL EGR VALVE ASSEMBLY
3.INSPECT FOR FUEL LEAK
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
5.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.
Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION