1.DRAIN DIFFERENTIAL OIL (except Torque Vectoring Differential)
Stop the vehicle on a level surface.
Using a 10 mm socket hexagon wrench, remove the rear differential filler plug and gasket.
Using a 10 mm socket hexagon wrench, remove the rear differential drain plug and gasket.
Drain the differential oil.
Install a new gasket and the rear differential drain plug.
2.DRAIN DIFFERENTIAL OIL (for Torque Vectoring Differential)
Stop the vehicle on a level surface.
Remove the 2 bolts.
Move aside the No. 2 differential disconnect cover as shown in the illustration.
Using a 10 mm socket hexagon wrench, remove the rear differential filler plug and gasket.
Using a 10 mm socket hexagon wrench, remove the rear differential drain plug and gasket.
Drain the differential oil.
Install a new gasket and the rear differential drain plug.
3.ADD DIFFERENTIAL OIL (except Torque Vectoring Differential)
| *a | 0 to 5 mm (0 to 0.196 in.) |
Add Toyota Genuine Differential gear oil LX SAE 75W-85 API GL-5 or equivalent.
Pour oil into the rear differential carrier assembly so that the oil level is within 0 to 5 mm (0 to 0.196 in.) of the bottom of the filler plug opening.
Excessively large or small quantities of oil may cause problems.
SAE 75W-85
Toyota genuine differential gear oil LX API GL-5 or equivalent
0.45 to 0.55 liters (0.48 to 0.58 US qts., 0.40 to 0.48 Imp. qts.)
Wait approximately 5 minutes and check that the oil level has not changed.
Using a 10 mm socket hexagon wrench, install a new gasket and the rear differential filler plug.
Drive the vehicle and check the oil level again. If necessary, add differential oil.
4.ADD DIFFERENTIAL OIL (for Torque Vectoring Differential)
| *a | 0 to 5 mm (0 to 0.196 in.) |
Add Toyota Genuine Differential gear oil LX SAE 75W-85 API GL-5 or equivalent.
Pour oil into the rear differential carrier assembly so that the oil level is within 0 to 5 mm (0 to 0.196 in.) of the bottom of the filler plug opening.
Excessively large or small quantities of oil may cause problems.
SAE 75W-85
Toyota genuine differential gear oil LX API GL-5 or equivalent
0.5 to 0.55 liters (0.53 to 0.58 US qts, 0.44 to 0.48 Imp. qts)
Wait approximately 5 minutes and check that the oil level has not changed.
Move aside the No. 2 differential disconnect cover as shown in the illustration.
| *a | 10 mm Straight Hexagon Wrench |
| *b | Union Nut Wrench |
| *c | Torque Wrench Fulcrum Length |
Using SST, 10 mm straight hexagon wrench and union nut wrench, install a new gasket and the rear differential filler plug.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + SST (fulcrum length of 150 mm (5.906 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)):
19.9 N*m (203 kgf*cm, 15 ft.*lbf)
Install the 2 bolts.
Drive the vehicle and check the oil level again. If necessary, add differential oil.