Home › Drivetrain › K120F (MULTIDRIVE / CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
RM3620E _52 Drivetrain _076273 K120F MULTIDRIVE / CVT _0372182 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM D

K120F MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  DTC CHECK / CLEAR  


HINT:
·

DTCs which are stored in the TCM can be displayed on the GTS.

·

The GTS can display pending DTCs and current DTCs. Some DTCs are not stored unless a malfunction is detected in a consecutive driving cycle. When a malfunction is detected in only one driving cycle, it is stored as a pending DTC.




CHECK DTC


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Transmission / Trouble Codes.

Powertrain > Transmission > Trouble Codes
50001 373

e.

Check for DTCs and freeze frame data, and write them down.

HINT:
GTS Display Description
Test Failed Shows the malfunction judgment results during the current trip.
Pending Shows the malfunction judgment results up to now. (Indicates the possibility of a malfunction when no DTC is confirmed.)
Confirmed Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.)



f.

Check the details of the DTCs.

Click hereDrivetrain>K120F (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART

NOTICE:

When simulating a symptom and using the GTS to check for DTCs, use normal mode. For DTCs in the Diagnostic Trouble Code Chart subject to "2-trip detection logic", perform the following:

Turn the ignition switch off after the symptom is simulated once. Then repeat the simulation process. When the symptom has been simulated twice, the MIL will illuminate and DTCs will be stored in the TCM.




CLEAR DTC


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Transmission / Trouble Codes.

Powertrain > Transmission > Clear DTCs
50002 373

e.

Clear the DTCs.