DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Key Unlock Warning SW | Unlock warning switch*1 | ON or OFF | ON: Key inserted into ignition key cylinder
OFF: Key removed from ignition key cylinder |
- |
| ACC SW | Ignition switch | ON or OFF | ON: Ignition switch ACC
OFF: Ignition switch off |
"ON" is also displayed for this item when the ignition switch is ON. |
| IG SW | Ignition switch | ON or OFF | ON: Ignition switch ON
OFF: Ignition switch off |
"OFF" is also displayed for this item when the ignition switch is ACC. |
| RR Door Courtesy SW | Rear door courtesy light switch RH | ON or OFF | ON: Rear door RH open
OFF: Rear door RH closed |
- |
| RL Door Courtesy SW | Rear door courtesy light switch LH | ON or OFF | ON: Rear door LH open
OFF: Rear door LH closed |
- |
| Back Door Courtesy SW | Back door courtesy light switch | ON or OFF | ON: Back door open
OFF: Back door closed |
- |
| FR Door Lock Pos | Front door RH unlock detection switch | LOCK or UNLOCK | LOCK: Front door RH locked
UNLOCK: Front door RH unlocked |
- |
| FR Door Courtesy SW | Front door courtesy light switch RH | ON or OFF | ON: Front door RH open
OFF: Front door RH closed |
- |
| FL Door Lock Pos | Front door LH unlock detection switch | LOCK or UNLOCK | LOCK: Front door LH locked
UNLOCK: Front door LH unlocked |
- |
| FL Door Courtesy SW | Front door courtesy light switch LH | ON or OFF | ON: Front door LH open
OFF: Front door LH closed |
- |
| Hood Courtesy SW | Engine hood courtesy switch | ON or OFF | ON: Engine hood open
OFF: Engine hood closed |
- |
| RR-Door Lock Pos SW | Rear door RH unlock detection switch signal*7 | ON or OFF | ON: Rear door RH unlocked
OFF: Rear door RH locked |
- |
| RL-Door Lock Pos SW | Rear door LH unlock detection switch signal*7
Rear door LH and RH unlock detection switch signal*8 |
ON or OFF | ON: Rear door RH unlocked*7
OFF: Rear door RH locked*7 ON: Rear door RH or LH unlocked*8 OFF: Rear door RH and LH locked*8 |
- |
| Intrusion Sens OFF SW | Intrusion sensor cancel switch*5 | ON or OFF | ON: Intrusion sensor cancel switch on
OFF: Intrusion sensor cancel switch off |
- |
| Intrusion Sensor | Status of the theft warning ultrasonic and tilt sensor detection*5 | ON or OFF | ON: One of the conditions below is met
·
Moving object detected by sensor ·
Vehicle tilt detected by sensor OFF: Both of the conditions below are met ·
No moving object detected by sensor ·
Vehicle tilt not detected by sensor |
- |
| Intrusion Sen Conn | Theft warning ultrasonic and tilt sensor connecting*5 | ON or OFF | ON: Theft warning ultrasonic and tilt sensor connected
OFF: Theft warning ultrasonic and tilt sensor not connected |
- |
| Sealed Glas Brak Sen | Glass breakage sensor connecting*6 | With or Without | With: Glass breakage sensor connected
Without: Glass breakage sensor not connected |
- |
| Intrusion Sensor Sound Detect | Sound detection status of the intrusion sensor (theft warning ultrasonic and tilt sensor) | ON or OFF | ON: Sound detected
OFF: Sound not detected |
Not applicable |
| Panic Function | This function operates the theft deterrent system when the panic switch is pressed and held for 0.8 seconds*2 | ON or OFF | Customization status displayed | - |
| Window Open Warning | This function is used to enable or disable the window open warning | ON or OFF | Customization status displayed | - |
| Slide Roof Open Warning | This function is used to enable or disable the sliding roof open warning*9 | ON or OFF | Customization status displayed | - |
| Warning by Horn | This function is used to enable or disable the warning by horn*3 | ON or OFF | Customization status displayed | - |
| Intrusion Win Opened | This function is used to set the sensitivity of the intrusion sensor when the windows are opened*5 | ON or OFF | Customization status displayed | - |
| Security control with mechanism key | This function makes it possible to cancel the security alarm with the mechanical key*4 | ON or OFF | Customization status displayed | - |
*1: w/o Entry and Start System
*2: w/ Panic Switch
*3: for vehicles displaying the item "Warning by Horn" on the GTS
*4: for vehicles displaying the item "Security control with mechanism key" on the GTS
*5: w/ Intrusion Sensor Cancel Switch
*6: w/ Glass Breakage Sensor
*7: w/ Memory
*8: w/o Memory
*9: w/ Sliding Roof System
ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. The Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body, Entry&Start or Immobiliser / Active Test.
According to the display on the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Security Indicator | Security indicator | ON or OFF | - |
| Security Horn2 | Theft warning siren assembly*1 | ON or OFF | - |
| Vehicle Horn | Vehicle horn | ON or OFF | - |
| Security Horn | Security horn assembly*2 | ON or OFF | - |
| Power For Intrusion Sensor | Theft warning ultrasonic and tilt sensor power supply*3 | ON or OFF | - |
*1: w/o Security Horn Assembly
*2: w/ Security Horn Assembly
*3: w/ Intrusion Sensor Cancel Switch
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Immobiliser Indicator | Security indicator* | ON or OFF | - |
*: w/ Entry and Start System
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Security Indicator | Security indicator* | ON or OFF | - |
*: w/o Entry and Start System