Use the same procedure as for the LHD and RHD vehicles.
84810
1.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
| *a | Component without harness connected
(Power Window Regulator Switch Assembly) |
Inspect the power window regulator switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 5 (UP) - 7 (GND) | UP(MANUAL) → OFF | Below 1 Ω → 10 kΩ or higher |
| 4 (DOWN) - 7 (GND) | DOWN(MANUAL) → OFF | Below 1 Ω → 10 kΩ or higher |
| 5 (UP) - 7 (GND)
5 (UP) - 8 (AUTO) |
UP(AUTO) → OFF | Below 1 Ω → 10 kΩ or higher |
| 4 (DOWN) - 7 (GND)
8 (AUTO) - 7 (GND) |
DOWN(AUTO) → OFF | Below 1 Ω → 10 kΩ or higher |
If the result is not as specified, replace the power window regulator switch assembly.