TERMINALS OF ECU
| *a | Component without harness connected
(Rack and Pinion Power Steering Gear Assembly) |
- | - |
The rack and pinion power steering gear assembly uses waterproof connectors. Therefore, voltage or waveforms cannot be checked with the connectors connected to the vehicle.
Use the Data List and Active Test on the GTS to check the operation of the rack and pinion power steering gear assembly and check that communication is established.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST
| Terminal No. (Symbol) | Terminal Description |
|---|---|
| C54-4 (IG) | IG power source |
| C54-7 (PGND) | Power ground |
| C54-8 (PIG) | Power source |
| C54-10 (CANH) | CAN communication line |
| C54-11 (CANL) | CAN communication line |
CHECK WIRE HARNESS SIDE CONNECTOR
| *a | Front view of wire harness connector
(to Rack and Pinion Power Steering Gear Assembly) |
- | - |
Disconnect the C54 rack and pinion power steering gear assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| C54-4 (IG) - Body ground | W - Body ground | IG power source | Ignition switch ON | 8 to 16 V |
| C54-7 (PGND) - Body ground | B - Body ground*1
W-L - Body ground*2 |
Power ground | Always | Below 1 Ω |
| C54-8 (PIG) - Body ground | R - Body ground*3
W - Body ground*4 L - Body ground*5 |
Power source | Always | 9 to 16 V |
*1: for A25A-FKS 4WD/AWD
*2: except A25A-FKS 4WD/AWD
*3: for HV RHD, Gasoline LHD A/T 2WD or Gasoline LHD CVT 2WD
*4: for HV LHD, Gasoline RHD
*5: for Gasoline LHD A/T 4WD/AWD, Gasoline LHD CVT 4WD/AWD or Gasoline LHD M/T