This DTC does not indicate a malfunction. The power steering ECU (rack and pinion power steering gear assembly) stores this DTC when it determines that torque sensor zero point calibration has not completed.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1516 | Torque Sensor Zero Point Adjustment Incomplete | Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration. | Torque sensor zero point calibration | EPS warning light: Comes on | The DTC is cleared | There is no malfunction if this DTC is not output again after clearing the DTC and torque sensor calibration value, and performing zero point calibration. |
If the rack and pinion power steering gear assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Clear the DTCs. (Step 1)
Calibrate the torque sensor zero point. (Step 2)
| Tester Display |
|---|
| Torque Sensor Adjustment |
Check for DTCs. (Step 3)
If DTCs are output, perform steps (1) to (3) two more times.
| Result | Proceed to |
|---|---|
| DTCs are still output after performing steering zero point calibration 3 times. | A |
| Normal system code is output. | B |
A
B