When a problem occurs in the PIG power source and power supply relay system, the fail-safe function works to stop the power assist.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1552 | PIG Power Supply Voltage | PIG power source circuit malfunction | ·
EPS fuse ·
Harness or connector ·
Rack and pinion power steering gear assembly |
EPS warning light: Comes on | Ignition switch is turned to ON again | - |
| C1554 | Power Supply Relay Failure | Power source relay circuit malfunction | ·
EPS fuse ·
Harness or connector ·
Rack and pinion power steering gear assembly |
EPS warning light: Comes on | Ignition switch is turned to ON again | - |
If the rack and pinion power steering gear assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the C54 rack and pinion power steering gear assembly connector.
| *a | Front view of wire harness connector
(to Rack and Pinion Power Steering Gear Assembly) |
- | - |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C54-8 (PIG) - Body ground | Ignition switch ON | 9 to 16 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C54-7 (PGND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG