Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)
RM3620E _56 Audio / Visual / Telematics _076047 AUDIO / VIDEO _0370280 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) L

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


NOTICE:

After the ignition switch is turned off, the audio and visual system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.



PRECAUTION FOR AUDIO AND VISUAL SYSTEM


NOTICE:
·

When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly may not operate normally.


·

When performing the following work, the audio and visual system may restart when turning the ignition switch to ACC (due to radio and display receiver assembly certification).

-

Repair or replace the negative (-) auxiliary battery terminal due to it being disconnected or depleted.

-

The radio and display receiver assembly replacement or removal and installation.


·

When replacing the DCM (telematics transceiver), make sure to replace it with a new one. (w/ Telematics Transceiver)



a.

If any of the following parts are replaced, refer to Initialization in Repair Instruction.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION

·

DCM (telematics transceiver)*


*: w/ Telematics Transceiver