Be sure to correctly follow the removal and installation procedures for the side airbag sensor assemblies.
1.INSPECT FLOOR SIDE AIRBAG SENSOR (for Vehicle not Involved in Collision)
Perform a diagnostic system check.
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
2.INSPECT FLOOR SIDE AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag not Deployed)
Perform a diagnostic system check.
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
Visually check the floor side airbag sensor for defects if a center pillar of the vehicle or the area around a center pillar is damaged.
The defects are as follows:
Cracks on the sensor housing
Dents on the sensor housing
Chips on the sensor housing
Cracks or other damage to the connector
Damage to the serial number
No defects are found.
If any defects are found, replace the floor side airbag sensor with a new one.
3.INSPECT FLOOR SIDE AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag is Deployed)
When airbags have deployed as the result of a collision, be sure to replace all floor side airbag sensors in the damaged areas (anywhere in need of repair).
Visually check the floor side airbag sensors in undamaged areas for defects.
The defects are as follows:
Cracks on the sensor housing
Dents on the sensor housing
Chips on the sensor housing
Cracks or other damage to the connector
Damage to the serial number
No defects are found.
If any defects are found or a floor side airbag sensor has detected a major collision, replace the floor side airbag sensor with a new one.