Be sure to correctly follow the removal and installation procedures for the rear airbag sensors.
1.INSPECT NO. 2 SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)
Perform a diagnostic system check.
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
2.INSPECT NO. 2 SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
Perform a diagnostic system check.
w/o Occupant Classification System:
for Gasoline Model with Occupant Classification System:
for HV Model with Occupant Classification System:
Visually check the No. 2 side airbag sensor assemblies for defects if a quarter panel of the vehicle or the area around a quarter panel is damaged.
The defects are as follows:
Cracks on the sensor housing
Dents on the sensor housing
Chips on the sensor housing
Cracks or other damage to the connector
Damage to the serial number
No defects are found.
If any defects are found, replace the No. 2 side airbag sensor assembly with a new one.
3.INSPECT NO. 2 SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)
When airbags have deployed as the result of a collision, be sure to replace all No. 2 side airbag sensor assemblies in the damaged areas (anywhere in need of repair).
Visually check the No. 2 side airbag sensor assemblies in undamaged areas for defects.
The defects are as follows:
Cracks on the sensor housing
Dents on the sensor housing
Chips on the sensor housing
Cracks or other damage to the connector
Damage to the serial number
No defects are found.
If any defects are found or a No. 2 side airbag sensor assembly has detected a major collision, replace the No. 2 side airbag sensor assembly with a new one.