Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81498
1.REMOVE REAR COMBINATION LIGHT COVER LH
|
Place Hands Here |
|
Remove in this Direction |
|
Protective Tape |
Apply protective tape as shown in the illustration.
Place your hand at the location shown in the illustration and detach the claw to remove the rear combination light cover LH.
81550L
2.REMOVE REAR TURN SIGNAL LIGHT BULB
|
Protective Tape |
Apply protective tape around the rear combination light assembly LH.
Remove the 2 screws.
| *a | Pin |
| *b | Guide |
|
Place Hands Here |
|
Pull in this Direction |
Place your hand at the location shown in the illustration and pull the rear combination light assembly LH toward the rear of the vehicle to detach the pin and guide to disconnect it.
Pull the rear combination light assembly LH straight towards the rear of the vehicle to prevent the guide from becoming damaged.
Support the rear combination light assembly LH with one hand.
| *a | Matchmark |
| *b | Unlock Position Mark |
|
Turn in this Direction |
Detach the 2 wire harness clamps.
Turn the bulb socket counterclockwise until the matchmark is aligned with the unlock position mark to disconnect the bulb socket.
|
Remove in this Direction |
Remove the rear turn signal light bulb from the bulb socket.