COMBINATION METER ASSEMBLY
Disconnect the G18 combination meter assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G18-38 (IG+) - Body ground | L - Body ground*1
B - Body ground*2 |
IG power supply | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V*3
10.5 to 16 V*4 |
|||
| G18-22 (B) - Body ground | B - Body ground | +B power supply | Ignition switch off | 11 to 14 V |
| G18-1 (B) - Body ground | B - Body ground | +B power supply | Ignition switch off | 11 to 14 V |
| G18-35 (ILL-) - Body ground*5 | L - Body ground | Illumination signal | Light control switch off | Below 1 V |
| Light control switch in tail or head position | 11 to 14 V | |||
| G18-19 (EP) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| G18-23 (ES) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
*1: except RHD with Stop and Start System
*2: for RHD with Stop and Start System
*3: w/o Stop and Start System
*4: w/ Stop and Start System
*5: w/ Light Control Rheostat Switch
Reconnect the G18 combination meter assembly connector.
Measure the voltage and resistance and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| G19-24 (INT) - Body ground*1 | L - Body ground | Tire pressure warning light signal | ·
Ignition switch ON ·
Steering pad switch assembly operated, "Set Pressure" selected on the multi-information display and "Enter" switch (steering pad switch assembly) pressed and held |
Below 1.5 V |
·
Ignition switch ON ·
"Enter" switch (steering pad switch assembly) off |
8 to 15 V | |||
| G18-20 (SI) - Body ground | W - Body ground | Speed signal for other system (Input) | Ignition switch ON, wheel being rotated | Pulse generation
(See waveform 1) |
| G18-36 (+S) - Body ground | L - Body ground | Speed signal for other system (Output) | Ignition switch ON, wheel being rotated | Pulse generation
(See waveform 1) |
| G18-14 (FV) - Body ground | GR - Body ground | Fuel sender gauge (Power source) | Ignition switch ON | Pulse generation
(See waveform 3) |
| G18-31 (FR) - G18-24 (FE&B) | LG - BE | Fuel level signal | Ignition switch ON, fuel level full → low (fuel level warning light on) | Pulse generation
(See waveform 2) |
| G18-13 (FR2) - G18-24 (FE&B)*2 | L - BE | Fuel level signal | Ignition switch ON, fuel level full → low (fuel level warning light on) | Pulse generation
(See waveform 2) |
| G18-24 (FE&B) - Body ground | BE - Body ground | Fuel sender gauge (Ground) | Always | Below 1 Ω |
| G19-14 (WLVL) - Body ground*3 | LG - Body ground | Washer fluid level signal | Ignition switch ON, washer fluid level not low | 11 to 14 V |
| Ignition switch ON, washer fluid level low | Below 1 V | |||
| G19-36 (RLSB) - Body ground | SB - Body ground | Rear LH seat beltbuckle switch signal | Ignition switch ON, rear seat belt warning light (LH) off | 11 to 14 V |
| Ignition switch ON, rear seat belt warning light (LH) on | Below 1 V | |||
| G19-19 (RCSB) - Body ground | B - Body ground | Rear center seat belt warning light output signal | Ignition switch ON, rear seat belt warning light (center) off | 11 to 14 V |
| Ignition switch ON, rear seat belt warning light (center) on | Below 1 V | |||
| G19-35 (RRSB) - Body ground | LG - Body ground | Rear RH seat belt warning light output signal | Ignition switch ON, rear seat belt warning light (RH) off | 11 to 14 V |
| Ignition switch ON, rear seat belt warning light (RH) on | Below 1 V | |||
| G18-25 (CANL) | W | CAN communication line | - | - |
| G18-9 (CANH) | B | CAN communication line | - | - |
| G18-10 (MSCL)*4 | W | Local bus communication line | - | - |
| G18-27 (MSCH)*4 | G | Local bus communication line | - | - |
| G18-28 (CXPI)*5 | B | CXPI communication line | - | - |
| G18-15 (MSTI) - Body ground | R - Body ground | Steering pad switch signal | Ignition switch ON, up, down, right and left switches on steering pad switch assembly not pushed | 4.3 to 5.2 V |
| Ignition switch ON, left switch on steering pad switch pushed | Below 0.6 V | |||
| Ignition switch ON, up switch on steering pad switch pushed | 1.0 to 2.2 V | |||
| Ignition switch ON, down switch on steering pad switch pushed | 2.3 to 3.4 V | |||
| Ignition switch ON, right switch on steering pad switch pushed | 3.4 to 4.5 V | |||
| G18-32 (MSM+) - Body ground | GR - Body ground | Steering pad switch signal | Ignition switch ON, enter and back switches on steering pad switch not pushed | 4.3 to 5.2 V |
| Ignition switch ON, enter switch on steering pad switch pushed | Below 0.6 V | |||
| Ignition switch ON, back switch on steering pad switch pushed | 1.0 to 2.2 V | |||
| G18-34 (SW1) - Body ground*6 | L - Body ground | Power source for light control rheostat | Ignition switch ON | 4.6 to 5.4 V |
| G18-16 (SW2) - Body ground*6 | G - Body ground | Light control rheostat signal | Light control rheostat fully turned left | Below 1 Ω |
| Light control rheostat fully turned right | 8 to 12 kΩ | |||
| G18-17 (TC) - Body ground*6 | B - Body ground | TAIL cancel switch signal | TAIL cancel switch on | Below 1 Ω |
| TAIL cancel switch off | 1 MΩ or higher | |||
| G18-11 (SW3) - Body ground*6 | B - Body ground | Light control rheostat ground | Always | Below 1 Ω |
| G19-18 (PBKL) - Body ground*7 | L - Body ground | Front passenger seat occupant detection sensor signal | Ignition switch ON, front passenger seat not occupied | 11 to 14 V |
| Ignition switch ON, front passenger seat occupied | Below 1 V | |||
| G19-34 (PBKL) - Body ground*7 | B - Body ground*8
G - Body ground*9 |
Front passenger seat belt buckle switch signal | Seat belt fastened | Below 1 V |
| Seat belt unfastened | 11 to 14 V | |||
| G19-31 (OILW) - Body ground | W - Body ground | Engine oil level signal | Ignition switch ON, engine oil level not low | Below 1 V |
| Ignition switch ON, engine oil level low | 11 to 14 V | |||
| G19-7 (LP) - Body ground | R - Body ground | Security indicator signal | Security indicator light off | Below 2 V |
| Security indicator light blinking | Pulse generation | |||
| G19-17 (HAZ) - Body ground | L - Body ground | Hazard warning signal switch signal (Output) | Hazard warning signal switch off | 11 to 14 V |
| Hazard warning signal switch on | Below 1 V | |||
| G19-16 (SW) - Body ground*2 | G - Body ground | Brake fluid level signal | Ignition switch ON, brake fluid level full | Below 1 V |
| Ignition switch ON, brake fluid level low (brake fluid level warning light on) | 11 to 14 V | |||
| G19-32 (VCM) - Body ground*2 | BE - Body ground | Vacuum warning switch signal | Vacuum warning switch off | 11 to 14 V |
| Vacuum warning switch on | Below 1 V | |||
| G19-26 (SFT1) - Body ground*10 | G - Body ground | Drive mode switch signal (SPORT mode) | Drive mode switch (SPORT mode) off | 11 to 14 V |
| Drive mode switch (SPORT mode) on | Below 1 V | |||
| G19-10 (SFT2) - Body ground*10 | R - Body ground*2
L - Body ground*13 |
Drive mode switch signal (NORMAL mode) | Drive mode switch (NORMAL mode) off | 11 to 14 V |
| Drive mode switch (NORMAL mode) on | Below 1 V | |||
| G19-27 (SFT3) - Body ground*10 | BE - Body ground*2
L - Body ground*13 |
Drive mode switch signal (ECO mode) | Drive mode switch (ECO mode) off | 11 to 14 V |
| Drive mode switch (ECO mode) on | Below 1 V | |||
| G19-6 (TRNR) - Body ground | B - Body ground*11
LA-B - Body ground*12 |
Rear turn signal light RH signal | Ignition switch ON, RH turn indicator light off | Below 1 V |
| Ignition switch ON, RH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | |||
| G19-5 (TRNL) - Body ground | BE - Body ground*11
LA-BE - Body ground*12 |
Rear turn signal light LH signal | Ignition switch ON, LH turn indicator light off | Below 1 V |
| Ignition switch ON, LH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | |||
| G19-2 (LR) - Body ground | G - Body ground | Front/side turn signal light RH signal | Ignition switch ON, RH turn indicator light off | Below 1 V |
| Ignition switch ON, RH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | |||
| G19-1 (LL) - Body ground | L - Body ground | Front/side turn signal light LH signal | Ignition switch ON, LH turn indicator light off | Below 1 V |
| Ignition switch ON, LH turn indicator light blinking | 11 to 14 V ←→ Below 1 V |
*1: w/ Tire Pressure Warning System
*2: for Gasoline Model
*3: w/ Washer Level Switch
*4: for Radio and Display Type
*5: for Radio Receiver Type
*6: w/ Light Control Rheostat Switch
*7: w/o Occupant Classification System
*8: for RHD
*9: for LHD without Occupant Classification System
*10: for Multi-information Display (7 Inch Display)
*11: for Manual Transaxle
*12: except Manual Transaxle
*13: for HV Model
If the result is not as specified, the combination meter assembly may be malfunctioning.
Waveform 1 (Reference):
| Item | Condition |
|---|---|
| Tester connection | ·
G18-20 (SI) - Body ground ·
G18-36 (+S) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Ignition switch ON, wheel being rotated |
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
Waveform 2:
| Item | Condition |
|---|---|
|
*: for Gasoline Model |
|
| Tester connection | ·
G18-31 (FR) - G18-24 (FE&B) ·
G18-13 (FR2) - G18-24 (FE&B)* |
| Tool setting | 2.5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Ignition switch ON, fuel level full → low (fuel level warning light on) |
(A) will differ depending on the fuel level.
Fuel level full: 4.2 to 4.6 V
Fuel level low (fuel level warning light on): 0.3 to 0.7 V
Waveform 3:
| Item | Condition |
|---|---|
| Tester connection | G18-14 (FV) - Body ground |
| Tool setting | 2.5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Ignition switch ON |
Ignition switch ON (4.5 to 5.5V)