Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM3620E _58 Vehicle Interior _076405 SEAT _0374976 SEAT HEATER SYSTEM U

SEAT  SEAT HEATER SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Seat Heater Temperature RH side front seat heater temperature -29.7°C to 59.55°C
·

HI: 39 to 40°C (102 to 104°F)

·

MID: 33 to 34°C (91 to 93°F)

·

LO: 27 to 28°C (81 to 82°F)


for HI/MID/LO Type Front Seat Heater
FL Seat Heater Temperature LH side front seat heater temperature -29.7°C to 59.55°C
·

HI: 39 to 40°C (102 to 104°F)

·

MID: 33 to 34°C (91 to 93°F)

·

LO: 27 to 28°C (81 to 82°F)


for HI/MID/LO Type Front Seat Heater
Number of Trouble Codes Number of trouble codes 0 to 255 Number of DTCs will be displayed -


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Front Right Seat Heater RH side front seat heater operation OFF/ON for HI/MID/LO Type Front Seat Heater
Front Left Seat Heater LH side front seat heater operation OFF/ON for HI/MID/LO Type Front Seat Heater
Rear Right Seat Heater RH side rear seat heater operation OFF/ON w/ Rear Seat Heater
Rear Left Seat Heater LH side rear seat heater operation OFF/ON w/ Rear Seat Heater