Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
81550L
1.REMOVE REAR TURN SIGNAL LIGHT BULB
| *a | Matchmark |
| *b | Unlock Position Mark |
|
Turn in this Direction |
Turn the bulb socket counterclockwise until the matchmark is aligned with the unlock position mark to disconnect the bulb socket.
|
Remove in this Direction |
Remove the rear turn signal light bulb from the bulb socket.
81536A
2.REMOVE REAR COMBINATION LIGHT LED
If the rear combination light LED has been removed, replace the rear combination light gasket LH with a new one.
Disconnect the connector.
Using a T20H "TORX" driver, remove the "TORX" screw.
| *a | Matchmark |
| *b | Unlock Position Mark |
|
Turn in this Direction |
Turn the rear combination light LED counterclockwise until the matchmark reaches the unlock position mark and remove it.
8158AC
3.REMOVE STOP LIGHT LED LH
If the stop light LED LH has been removed, replace the rear combination light gasket LH with a new one.
Disconnect the connector.
Using a T20H "TORX" driver, remove the "TORX" screw.
| *a | Matchmark |
| *b | Unlock Position Mark |
|
Turn in this Direction |
Turn the stop light LED LH counterclockwise until the matchmark reaches the unlock position mark and remove it.
81552C
4.REMOVE REAR COMBINATION LIGHT GASKET LH
The rear combination light gasket LH cannot be reused.
| *A | for rear combination light LED |
| *B | for stop light LED LH |
Remove the rear combination light gasket LH from the rear combination light LED.
Remove the rear combination light gasket LH from the stop light LED LH.
81555H
5.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE
Detach the wire harness clamp to remove the rear combination light socket and wire.