Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81555H
1.INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE
Attach the wire harness clamp to install the rear combination light socket and wire.
81552C
2.INSTALL REAR COMBINATION LIGHT GASKET LH
| *A | for rear combination light LED |
| *B | for stop light LED LH |
Install a new rear combination light gasket LH to the rear combination light LED.
Install a new rear combination light gasket LH to the stop light LED LH.
8158AC
3.INSTALL STOP LIGHT LED LH
| *a | Matchmark |
| *b | Unlock Position Mark |
| *c | Lock Position Mark |
|
Turn in this Direction |
Align the matchmark with the unlock position mark and install the stop light LED LH by turning it clockwise to the lock position mark.
Using a T20H "TORX" driver, install the "TORX" screw.
Connect the connector.
81536A
4.INSTALL REAR COMBINATION LIGHT LED
| *a | Matchmark |
| *b | Unlock Position Mark |
| *c | Lock Position Mark |
|
Turn in this Direction |
Align the matchmark with the unlock position mark and install the rear combination light LED by turning it clockwise to the lock position mark.
Using a T20H "TORX" driver, install the "TORX" screw.
Connect the connector.
81550L
5.INSTALL REAR TURN SIGNAL LIGHT BULB
|
Install in this Direction |
Install the rear turn signal light bulb to the bulb socket.
| *a | Matchmark |
| *b | Unlock Position Mark |
| *c | Lock Position Mark |
|
Turn in this Direction |
Align the matchmark of the bulb socket with the unlock position mark, and then turn the bulb socket clockwise until the lock position mark to connect the bulb socket.