Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81582
1.REMOVE REAR LIGHT GASKET
Remove the 3 rear light gaskets.
Do not reuse the rear light gasket.
| *a | When removing from the rear light assembly LH | *b | When removing from the vehicle |
81550N
2.REMOVE BACK-UP LIGHT BULB
| *a | Unlock Position Mark |
|
Turn in this Direction |
Detach the wire harness clamp.
Turn the bulb socket counterclockwise until it is aligned with the unlock position mark to disconnect the bulb socket.
|
Remove in this Direction |
Remove the back-up light bulb from the bulb socket.
81595
3.REMOVE REAR LIGHT SOCKET AND WIRE LH
| *A | w/ Rear Fog Light |
|
Protective Tape |
Using a screwdriver, detach the claw and disconnect the connector.
Tape the screwdriver tip before use.
Detach the wire harness clamp.
Disconnect each connector to remove the rear light socket and wire LH.
8159A
4.REMOVE REAR LIGHT LED LH
Using a T20H "TORX" driver, remove the "TORX" screw.
| *a | Matchmark |
| *b | Unlock Position Mark |
|
Turn in this Direction |
Turn the rear light LED LH counterclockwise until the matchmark is aligned with the unlock position mark and remove it.
81589A
5.REMOVE REAR LIGHT GASKET
Remove the rear light gasket.
The rear light gasket cannot be reused.
76827A
6.REMOVE NO. 2 BACK DOOR GARNISH RETAINER
Using a T20H "TORX" driver, remove the "TORX" screw.
Detach the guide to remove the No. 2 back door garnish retainer.