Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
76827A
1.INSTALL NO. 2 BACK DOOR GARNISH RETAINER
Attach the guide to set the No. 2 back door garnish retainer.
Using a T20H "TORX" driver, install the "TORX" screw.
81589A
2.INSTALL REAR LIGHT GASKET
Install a new rear light gasket.
8159A
3.INSTALL REAR LIGHT LED LH
| *a | Matchmark |
| *b | Unlock Position Mark |
| *c | Lock Position Mark |
|
Turn in this Direction |
Align the matchmark of the rear light LED LH with the unlock position mark, and then turn the rear light LED LH clockwise until the lock position mark to install it.
Using a T20H "TORX" driver, install the "TORX" screw.
81595
4.INSTALL REAR LIGHT SOCKET AND WIRE LH
| *A | w/ Rear Fog Light |
Connect each connector.
Attach the wire harness clamp.
Attach the claw to connect the connector.
81550N
5.INSTALL BACK-UP LIGHT BULB
|
Install in this Direction |
Install the back-up light bulb to the bulb socket.
| *a | Unlock Position Mark |
| *b | Lock Position Mark |
|
Turn in this Direction |
Align the bulb socket to the unlock position mark, and then turn the bulb socket clockwise until the lock position mark to connect the bulb socket.
Attach the wire harness clamp.
81582
6.INSTALL REAR LIGHT GASKET
Install new 3 rear light gaskets.