Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM3620E _59 Vehicle Exterior _077130 LIGHTING (EXT) _0375604 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89408C 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.

Check the rear height control sensor sub-assembly LH.

i.

Connect 3 dry batteries of 1.5 V in series.


ii.

Connect the positive (+) end of the batteries to terminal 3 (SHB) of the rear height control sensor sub-assembly LH and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG).

NOTICE:
·

Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

·

Do not apply a voltage of more than 6 V.



E404132C01
5.438,2.167 5.885,1.5 true 4.292,1.833 5.073,2.177 true 4.906,2.906 5.24,2.25 true 4.24,0.99 4.552,1.146 0.313,0.156 10 false *a 1.5,0.74 1.813,0.896 0.313,0.156 10 false *b 1.646,0.615 1.958,0.771 0.313,0.156 10 false *c 2.76,0.615 3.073,0.771 0.313,0.156 10 false *d 1.094,2.25 1.26,2.427 0.167,0.177 10 true *e 3.885,0.74 4.198,0.896 0.313,0.156 10 false *f 5.927,1.396 6.385,1.594 0.458,0.198 10 false SHG 4.698,2.958 5.229,3.198 0.531,0.24 10 false SHRR 3.948,1.729 4.406,1.927 0.458,0.198 10 false SHB 1.698,3.188 2.01,3.396 0.313,0.208 10 false *g
*a Component without harness connected
(Rear Height Control Sensor Sub-assembly LH)
*b Horizontal Position
*c Standard position
(5.4° from horizontal position)
*d Height low (Full bound)
(38.8° from standard position)
*e Height high (Full rebound)
(64.4° from standard position)
*f Bound side link stop position
(85° from standard position)
*g Rebound side link stop position
(102° from standard position)
- -



iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition

If the result is not as specified, replace the rear height control sensor sub-assembly LH.

1 (SHG) - 2 (SHRR) Link moves upward from standard position to bound side (Height low) From 38.8° to bound side link stop position Approx. 0.5 V
38.8° (Full Bound) Approx. 0.7 V
Standard position - Approx. 2.25 V
Link moves downward from standard position to rebound side (Height high) Horizontal Position Approx. 2.47 V
64.4° (Full Rebound) Approx. 4.5 V
From 64.4° to rebound side link stop position Approx. 4.5 V