Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM3620E _59 Vehicle Exterior _077130 LIGHTING (EXT) _0375604 HEIGHT CONTROL SENSOR A

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the rear height control sensor sub-assembly LH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor sub-assembly LH or replacement of suspension components Initialization of the headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)

PROCEDURE

Hide 89408C 1.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.
E404131C03
0,0 0,0 false
V100135

Bolt
V100136

Nut
V100137

Connector


Disconnect the connector.


b.

Remove the bolt and nut.


c.

Detach the hook and remove the rear height control sensor sub-assembly LH.


d.
E406966C01
0,0 0,0 false
V113147

Pull Out in this Direction


Pull out the rear height control sensor bracket from the No. 2 lower arm.

NOTICE:

If the rear height control sensor sub-assembly LH has been dropped, replace it with a new one.