Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER SYSTEM (for HV Model)
RM3620E _59 Vehicle Exterior _076404 EXTERIOR PANELS / TRIM _0375824 GRILLE SHUTTER SYSTEM(for HV Model) C

EXTERIOR PANELS / TRIM  GRILLE SHUTTER SYSTEM(for HV Model)  B1333  Shutter Control State Maintenance Mode  


DESCRIPTION

This DTC is stored when the grille shutter system is changed to maintenance mode.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1333 Shutter Control State Maintenance Mode The grille shutter system is changed to maintenance mode. Swing grille actuator assembly

CAUTION / NOTICE / HINT

NOTICE:

If the swing grille actuator assembly has been replaced with a new one, perform initialization and change the grille shutter control mode.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>GRILLE SHUTTER SYSTEM (for HV Model)>INITIALIZATION


PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Grille Shutter > Clear DTCs
50002 352

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Grille Shutter > Trouble Codes
50001 352
OK:

DTC B1333 is not output.



Result:
Proceed to
OK
NG



OK

3.CHANGE GRILLE SHUTTER CONTROL MODE

NG

3.CHANGE GRILLE SHUTTER CONTROL MODE
a.

Change the grille shutter control mode to normal mode.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>GRILLE SHUTTER SYSTEM (for HV Model)>INITIALIZATION


Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTC
4.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Grille Shutter > Trouble Codes
50001 352
OK:

DTC B1333 is not output.



Result:
Proceed to
OK
NG



OK

END (GRILLE SHUTTER CONTROL MODE WAS NOT CHANGED)

NG

REPLACE SWING GRILLE ACTUATOR ASSEMBLY