Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)
RM3620E _56 Audio / Visual / Telematics _076047 AUDIO / VIDEO _0370280 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Voice Guidance Circuit between Radio Receiver and Stereo Component Amplifier  


DESCRIPTION

This circuit is used when the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the radio and display receiver assembly sends signals to the stereo component amplifier assembly.

WIRING DIAGRAM

E362170E19
5.615,0.688 6.073,0.885 0.458,0.198 10 false RL+ 5.615,1.479 6.073,1.677 0.458,0.198 10 false RL- 1.313,1.469 1.771,1.667 0.458,0.198 10 false II1- 1.281,0.688 1.74,0.885 0.458,0.198 10 false II1+ 1.177,2.26 1.635,2.458 0.458,0.198 10 false SLD1 5.354,0.563 5.667,0.76 0.313,0.198 10 false 3 5.354,1.375 5.667,1.573 0.313,0.198 10 false 8 1.635,0.583 1.948,0.781 0.313,0.198 10 false 15 1.646,1.385 1.958,1.583 0.313,0.198 10 false 14 0.667,2.802 1.885,3.229 1.219,0.427 10 false Stereo Component Amplifier Assembly 5.531,2.865 6.75,3.271 1.219,0.406 10 false Radio and Display Receiver Assembly 0.677,2.656 1.135,2.854 0.458,0.198 10 false M3 5.542,2.698 6,2.896 0.458,0.198 10 false G4 1.646,2.146 1.958,2.344 0.313,0.198 10 false 18 2.719,1.823 3.177,2.021 0.458,0.198 10 false * 0.24,3.469 1.177,3.74 0.938,0.271 10 false *: Shielded

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
a.

Disconnect the G4 radio and display receiver assembly connector.


b.

Disconnect the M3 stereo component amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G4-3 (RL+) - M3-15 (II1+) Always Below 1 Ω
G4-8 (RL-) - M3-14 (II1-) Always Below 1 Ω
M3-18 (SLD1) - Body ground Always 10 kΩ or higher
G4-3 (RL+) - Body ground Always 10 kΩ or higher
G4-8 (RL-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR