This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
44777
1.DISCONNECT NO. 1 VACUUM HOSE CONNECTOR
| *a | Retainer |
|
Pinch |
|
Pull off |
Pinch the retainer of the No. 1 vacuum hose connector, and then pull the No. 1 vacuum hose connector off of the vacuum pump assembly.
Be sure to disconnect the No. 1 vacuum hose connector by hand.
82121
2.SEPARATE ENGINE WIRE
Disengage the clamp to separate the engine wire.
Disconnect the connector to separate the engine wire.
Disengage the clamp to separate the engine wire.
29300
3.REMOVE VACUUM PUMP ASSEMBLY
Using an 8 mm socket wrench, remove the 3 bolts and vacuum pump assembly from the engine assembly.
Remove the No. 1 vacuum pump O-ring from the vacuum pump assembly.