This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
89458H
1.INSTALL NO. 2 FUEL PRESSURE SENSOR
Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.
w/ Canister Pump Module:
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module:
Install a new O-ring to the No. 2 fuel pressure sensor.
Set the No. 2 fuel pressure sensor to the fuel delivery pipe sub-assembly.
Do not allow dust or dirt to enter the No. 2 fuel pressure sensor.
If a No. 2 fuel pressure sensor is dropped or struck, replace it with a new one.
Temporarily install the No. 2 fuel pressure sensor holder to the No. 2 fuel pressure sensor.
Install the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the bolt.
Connect the connector to the No. 2 fuel pressure sensor.
23807
2.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.
w/ Canister Pump Module:
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module: