84010D
1.INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (BRAKE HOLD SWITCH (except Manual Transaxle))
| *a | Component without harness connected
Integration Control and Panel Assembly (Brake Hold Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 15 (E) - 24 (+B) | Switch pushed | Below 1 Ω |
| 15 (E) - 24 (+B) | Switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the integration control and panel assembly (brake hold switch).
84390A
2.INSPECT BRAKE WARNING SWITCH ASSEMBLY (BRAKE HOLD SWITCH (for Manual Transaxle))
Check the resistance.
| *a | Component without harness connected
Brake Warning Switch Assembly (Brake Hold Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 10 (+B) - 12 (E) | Switch pushed | Below 1 Ω |
| 10 (+B) - 12 (E) | Switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the brake warning switch assembly (brake hold switch).