Home › Engine / Hybrid System › A25A-FKS (ENGINE CONTROL) › SFI SYSTEM (w/o Canister Pump Module)
RM3620E _51 Engine / Hybrid System _076382 A25A-FKS ENGINE CONTROL _0376982 SFI SYSTEM(w/o Canister Pump Module) L

A25A-FKS ENGINE CONTROL  SFI SYSTEM(w/o Canister Pump Module)  PRECAUTION  


WHEN USING GTS


CAUTION:

Observe the following items for safety reasons:


·

Before using the GTS, read the instruction manual.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes using the GTS, 2 persons are required. One drives the vehicle, and the other operates the GTS.


CAUTION:
·

Strictly obey all traffic rules and regulations

·

Do not drive the vehicle with the GTS cable contacting the pedals, shift lever or steering wheel.

·
A371909

Driving the wheel with the GTS cable contacting these areas could impede vehicle control, resulting in a serious accident.

·
A356953

Do not operate the GTS while driving the vehicle.

·

Operating the GTS while driving the vehicle will prevent you from paying sufficient attention to vehicle surroundings, and could result in a serious accident.




INITIALIZATION


NOTICE:
·

Before replacing the ECM, refer to Service Bulletin (for Immobiliser System).

·

Perform Registration (VIN or frame number registration) after replacing the ECM.

Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>REGISTRATION

·

Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation.

Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>INITIALIZATION

·

Make sure to perform Reset Memory (A/T initialization), when replacing the ECM.


·

When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION

·

Perform "Grille Shutter Control Mode Switching and Grille Shutter Initialization" after replacing the swing grille actuator assembly or radiator shutter sub-assembly.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>GRILLE SHUTTER SYSTEM (for Gasoline Model)>INITIALIZATION