Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
65632B
1.REMOVE REAR WHEEL FRONT HOUSE PLATE LH
75606A
2.REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH (except Off Road Package)
|
Screw |
|
Clip |
Remove the screw and 2 clips.
|
Protective Tape |
Apply protective tape around the quarter outside moulding sub-assembly LH.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the location indicated shown in the illustration, pull the quarter outside moulding sub-assembly LH and detach the claw and clip.
To avoid damaging the claw, do not forcibly pull the quarter outside moulding sub-assembly LH.
| *a | Base |
|
Remove in this Direction |
Pull the quarter outside moulding sub-assembly LH outside to disconnect the clip from the base.
Using a clip remover, detach the clip remaining on the vehicle and install the quarter outside moulding sub-assembly LH.
75606A
3.REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH (for Off Road Package)
When removing the quarter outside moulding sub-assembly LH, if the double-sided tape is difficult to remove, heat the vehicle body and quarter outside moulding sub-assembly LH using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 20 to 30°C (68 to 86°F) |
| Quarter Outside Moulding Sub-assembly LH |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body and quarter outside moulding sub-assembly LH excessively.
|
Screw |
|
Clip |
Remove the screw and 2 clips.
|
Protective Tape |
Apply protective tape around the quarter outside moulding sub-assembly LH.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the location indicated shown in the illustration, pull the quarter outside moulding sub-assembly LH and detach the clip and guide.
| *a | Double-sided Tape |
|
Place Hand Here |
|
Remove in this Direction |
Hold the area shown in the illustration and detach the clip, double-sided tape to remove the quarter outside moulding sub-assembly LH.
| *a | Base |
|
Remove in this Direction |
Pull the quarter outside moulding sub-assembly LH forward to disconnect the clip from the base.
Using a clip remover, detach the clip remaining on the vehicle and install the quarter outside moulding sub-assembly LH.
75874
4.REMOVE QUARTER PANEL WHEEL OPENING MOULDING LH
When removing the quarter panel wheel opening moulding LH, if the double-sided tape is difficult to remove, heat the vehicle body and quarter panel wheel opening moulding LH using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 20 to 30°C (68 to 86°F) |
| Quarter Panel Wheel Opening Moulding LH |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body and quarter panel wheel opening moulding LH excessively.
| *a | Double-sided Tape |
|
Remove in this Direction |
Remove the clip.
Detach the clip and double-sided tape and remove the quarter panel wheel opening moulding LH as shown in the illustration.