Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
62792V
1.INSTALL QUARTER WINDOW UPPER MOULDING LH
When installing a new quarter window upper moulding LH, heat the vehicle body and quarter window upper moulding LH using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Quarter Window Upper Moulding LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body and quarter window upper moulding LH excessively.
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove any remaining double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Installing the quarter window upper moulding LH with some double-sided tape remaining may cause poor adhesion. Perform this procedure until the tape is sufficiently removed.
Make sure to use a cloth when removing. Using a screwdriver, etc., may cause damage and poor adhesion.
Remove the peeling paper of a new quarter window upper moulding LH trying not to touch the adhesional surface.
| *a | Double-sided Tape |
|
Install in this Direction |
Attach the clip and double-sided tape to install the quarter window upper moulding LH as shown in the illustration.
Press the quarter window upper moulding LH firmly to install it.
Remove the protective tape.