Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84930
1.INSPECT DOOR CONTROL SWITCH ASSEMBLY (for Front Passenger Side)
| *a | Lock Switch |
| *b | Unlock Switch |
| *c | Component without harness connected
(Door Control Switch Assembly) |
Check the switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (L) - 5 (E) | Lock switch pushed | Below 1 Ω |
| 4 (L) - 5 (E) | Lock switch not pushed | 10 kΩ or higher |
| 2 (UL) - 5 (E) | Unlock switch not pushed | 10 kΩ or higher |
| 2 (UL) - 5 (E) | Unlock switch pushed | Below 1 Ω |
If the result is not as specified, replace the door control switch assembly.