1.RELEASE PARKING BRAKE
for Manual Transaxle: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>REMOVAL
except Manual Transaxle: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>REMOVAL
17410
2.REMOVE FRONT EXHAUST PIPE ASSEMBLY
for A25A-FKS:Click hereEngine / Hybrid System>A25A-FKS (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL
for M20A-FKS:Click hereEngine / Hybrid System>M20A-FKS (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL
58152A
3.REMOVE LOWER NO. 1 FRONT FLOOR HEAT INSULATOR
w/ Floor Under Cover:
Remove the 3 nuts and lower No. 1 front floor heat insulator.
w/o Floor Under Cover:
Remove the 3 nuts and lower No. 1 front floor heat insulator.
37110
4.REMOVE PROPELLER SHAFT ASSEMBLY
Remove the 2 bolts and 2 center No. 2 support bearing washers, and disconnect the propeller with center bearing shaft assembly.
During the removal, do not exert excessive force on the universal joint.
When removing, transporting or storing the propeller with center bearing shaft assembly, do not allow the No. 2 joint angle to exceed 20°.
| *a | Matchmark |
Place matchmarks on the differential carrier assembly and propeller with center bearing shaft assembly.
Remove the 4 nuts and 4 washers, and disconnect the propeller with center bearing shaft assembly from the differential carrier assembly.
| *a | Matchmark |
Place matchmarks on the transfer assembly and propeller with center bearing shaft assembly.
Remove the 4 nuts and 4 washers, and disconnect the propeller with center bearing shaft assembly from the transfer assembly.