Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH
RM3620E _59 Vehicle Exterior _076564 WIPER / WASHER _0377484 WASHER LEVEL WARNING SWITCH A

WIPER / WASHER  WASHER LEVEL WARNING SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85397 1.INSPECT LEVEL WARNING SWITCH ASSEMBLY

HINT:

This check should be performed with the level warning switch assembly installed on the windshield washer jar assembly.


a.

Add washer fluid to the windshield washer jar.


b.
E158668C25
2.031,1.292 2.656,1.292 true 0.677,1.302 1.385,1.302 true 0.146,0.156 0.458,0.354 0.313,0.198 10 false *a 2.74,1.229 3.052,1.427 0.313,0.198 10 false S 0.552,1.24 0.865,1.438 0.313,0.198 10 false E
*a Component without harness connected
(Level Warning Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (S) - 2 (E) Fluid volume is 600 to 800 cc (36.6 to 48.8 cu. in.) or more* 10 kΩ or higher
1 (S) - 2 (E) Fluid volume is 600 to 800 cc (36.6 to 48.8 cu. in.) or less* Below 1 Ω


HINT:
·

Perform checks by reducing the amount of washer fluid.

·

*: The level warning switch assembly activates when the washer fluid is 600 to 800 cc (36.6 to 48.8 cu.in.) or less according to the vehicle condition (vehicle stability etc.)



If the result is not as specified, replace the level warning switch assembly.